^
Clean all parts with a solution of hot
water and washing up liquid. If
neccessary, a small brush can be
used to remove any stubborn milk
deposits.
^
Rinse all parts carefully under
running water.
^
Then dry them carefully.
Reassemble the cappuccinatore in the
reverse order:
^
First replace the locking disc
followed by the dial on the
cappuccinatore.
^ Then replace the milk tube and
nozzles.
^ Fit the cappuccinatore on to the
steam and water spout from below.
Water container
Change the water every day to prevent
a build-up of bacteria.
Make sure that the valve, the
underside of the water container and
the surface the water container sits
on are clean. Otherwise the water
container will not sit correctly.
^
The water container can be cleaned
in the dishwasher, or by hand using
hot water and a little washing-up
liquid.
^ After cleaning, dry the water
container.
^ Clean the surface the water container
sits on, particularly the slots,
carefully.
Cleaning and care
49
To Next Page
Loading...
