Miele CM5300 - Water Hardness; Display Brightness; Volume; Factory Default Setting

Settings
42
Water hardness
Information regarding water hardness is
given in the "Water hardness" chapter.
Display brightness
Change the display brightness using
the arrow sensors .
Volume
You can set the volume of buzzer and
sensor tones using the arrow
sensors.
Tip: To switch off the tones, touch the
arrow sensor, until no segments are
filled and Switched offappears.
Factory default setting
You can reset the coffee machine to its
factory default settings.
The number of drinks and the machine
status (No. of drinks until the machine
must be descaled, ... Degrease the
brew unit) cannot be reset.
Please refer to the "Possible setting
options" chart for the factory settings.
The following settings will not be
reset:
– Language
– Profiles and their drinks
Demo mode (Showroom
programme)
Do not activate this setting for
domestic use!
The coffee machine can be
demonstrated in the showroom using
theShowroom programme. In this mode
the machine lights up but drinks cannot
be made or actions taken.
If you activate the Demo mode, you
cannot switch the appliance off with
the On/Off sensor.