en
39
When using the adjustable floorhead,
if the suction seems too high, reduce
the suction power until the floorhead
is easier to manoeuvre.
Turn the suction power selector
manually to the power level you re-
quire.
Opening the air inlet valve (Fig. 25)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other textile flooring being sucked into
the vacuum cleaner.
Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to man-
oeuvre.
During vacuuming
When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.
Setting down, transportation
and storage
Park system for pauses during vacu-
uming (Fig. 26)
The Park system allows you to conveni-
ently park the suction tube and floor-
head during brief pauses.
Slot the floorhead into the slot in the
parking attachment.
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp,
– Retract the telescopic suction tube
fully
– Do not use the park system if your
vacuum cleaner has an EasyLock
suction tube.
Park system for storage (Fig. 27 + 28)
Risk of electric shock from mains
voltage.
The mains voltage is applied to the
appliance even if it is switched off.
After use, switch the appliance off at
the wall socket and unplug it.
Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele-
scopic suction tube, retract the tubes
fully so that it takes up less room for
storage.
Slot the floorhead downwards into
the parking attachment.
If your vacuum cleaner has an Easy-
Lock suction tube, you can detach this
so that the vacuum cleaner requires
less storage space.
Press the release catch on the lower
suction tube section and pull the top
section out.
Push the connection piece attached
to the upper suction tube into the
lower suction tube.
To Next Page
Loading...
Need help?
General
