Miele Complete C3 SG 3 Series User Manual

en
56
 Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces (dia. 01).
Replacing the motor protection filter
(dia. 40)
Replace the motor protection filter
whenever you start a new packet of
dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters (available depending on country).
 Open the dust compartment lid.
 Pull the dustbag out by the grip on
the collar.
 Lift up the filter frame until it clicks
and remove the old filter. Hold by the
clean, unsoiled section to remove it.
 Replace with a new motor protection
filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
Replacing the exhaust filter
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
Replace this filter every time you start a
new packet of Miele dustbags. Every
packet of original Miele dustbags con-
tains one AirClean exhaust filter. Mul-
tipacks contain four AirClean filters
(available depending on country).
bAirClean Plus 50 (light blue)
Replace this filter after approx. one
year. Make a note of the date on the fil-
ter.
cSilence AirClean 50 (grey)
dActive AirClean 50 (black)
eHEPA AirClean 50 (white)
Replace this filter when the exhaust fil-
ter TimeStrip® change indicator is
completely red (dia. 17). The indicator
lights up after approximately 50 hours
of operation, which is equivalent to
about a year of average use. You can
continue vacuuming when the light
comes on. However, the suction power
will be reduced as will the effectiveness
of the filter if it is not replaced in good
time.
Replacing the AirClean
filter(dia. 41 + 42)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille as far as it
will go.
 Grasp the used AirClean filter by one
of the clean, unsoiled sections and
take it out.
 Replace it with a new AirClean ex-
haust filter.

Miele Complete C3 SG 3 Series Specifications

General

Brand	Miele
Model	Complete C3 SG 3 Series
Category	Vacuum Cleaner
Language	English