Miele CVA 5065 - Adjusting the door hinges

If it is not:
^
realign the machine by adjusting the
four feet.
The feet can be unscrewed by up to
approx. 10 mm.
^
Plumb the appliance into the mains
water supply.
^
Connect the appliance to the
electricity supply.
^
Push it all the way into the niche until
you feel resistance.
^ Open the machine door, and partially
tighten the side socket screws.
^
Carefully turn the lower socket
screws a to centre the machine in
the niche.
^
Tighten both upper socket screws b
by hand to secure the machine in the
unit. Do not overtighten them.
Adjusting the door hinges
If the machine door becomes difficult to
open or close after installation you can
adjust the hinges to realign it:
^ To adjust the door in direction a,
turn screw a.
^ To adjust the door forwards or
backwards (direction b), turn screw
b.
Installation
82