Miele CVA 7440 - Page 73

Problem solving guide
73
Issue Cause and remedy
F73 or
Check the brew unit
The brew unit cannot be positioned correctly or is
soiled. It is not possible to press the ground coffee.
 Check whether you can remove the brew unit.
 If you can remove the brew unit, rinse it under
running water.
 Push the coffee ejector of the brew unit into the
correct position (see illustration).
 Place the water container in the coffee machine
and close the machine door. Do not insert the
brew unit. Switch the coffee machine on.
This will initialise the brew unit motor and put it back
into the start position.
 When Insert the brew unit appears in the display, put
the brew unit back in the coffee machine. Close
the machine door.
 If you cannot remove the brew unit, switch the
coffee machine off. Wait for
approximately2minutes before switching the
machine back on again.
A maintenance
programme is
prematurely aborted
and the following
appears in the display:
Push the water container in
until it engages.
The water container has not been filled and inserted
correctly.
 Check that you have selected the correct mark.
The symbols marked on the water container indicate
the amount of water required for the
Descale the appliance: and Clean the milk pipework:
maintenance programmes.
 Fill the water container up to the relevant mark and
restart the process.