^
Clean the filter
– by hand: with a nylon brush, warm
water with a little washing up liquid.
– in a dishwasher: place the filter
with the short side upright in the
lower basket, ensuring the spray arm
is not obstructed.
Note: some dishwasher detergents
may cause the surface of the metal
grease filter to discolour.
However, this will not affect the func
-
tioning of the grease filter in any
way.
^ After cleaning leave the filter to dry
for a while on an absorbent surface
before putting it back in place.
^ When cleaning the stainless steel fil-
ter please also follow the cleaning in-
structions given for the housing.
^ When removing the filters for clean-
ing also clean off any residues of oil
or fat from the now accessible hous-
ing to prevent the risk of these catch
-
ing fire.
^
After replacing the grease filter, press
the grease filter touch control for
approx. 3 seconds to re-set the oper
-
ating hours counter.
The indicator lamp will go out.
^
If the grease filter is cleaned before
the operating hours counter has
reached its maximum, the grease fil
-
ter touch control should be pressed
for approx. 6 seconds to reset the
counter to zero.
Replace the grease filter
^
Holding the grease filter at an angle
fit it into the front of the chimney and
then push it into position along the
front edge.
^ Then push it up into position at the
back making sure it clicks into posi-
tion at both sides.
Replace the stainless steel filter
^
Fit the stainless steel filter into the ap
-
pliance so that it hooks into the re
-
tainers at the back, then push it up
-
wards at the front and make sure it
engages in the quick release mecha
-
nism.
Cleaning and care
19
To Next Page
Loading...
