To remove the vapour plate
^
Pull the vapour plate down towards
you at the top, push the bottom
slightly to the right and pull forwards
to remove (see illustration).
To remove the grease filter
^
Pull the grease filter by the hand-hold
forwards and out.
Cleaning the grease filter by hand
^
Clean the filter with a soft nylon brush
in a mild solution of hot water and a
small amount of washing-up liquid.
Do not use undiluted washing up
liquid.
Do not use:
–
cleaning agents containing
descaling agents,
–
powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filter in the
dishwasher
^ Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^
Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^
After cleaning, leave the filter to dry
for a while on an absorbent surface
before putting it back in place.
Cleaning and care
23
To Next Page
Loading...
