To Next PageTo Next Page
Need help?Do you have a question about the Miele DA 329 i and is the answer not in the manual?
General| Type | Built-in |
|---|---|
| Noise Level | 64 dB |
| Lighting | LED |
| Filter Type | Metal grease filter |
| Control Type | Electronic |
| Fluid dynamic efficiency class | A |
| Lighting efficiency class | A |
| Colour | Stainless Steel |
| Number of Fan Speeds | 3 |
| Material | Stainless Steel |
Information on environmentally friendly disposal of packaging materials and safety for children.
Guidance on recycling old appliances and ensuring safety during storage.
Specifies the intended domestic use of the appliance and the manufacturer's liability.
Covers electrical safety, earthing requirements, and qualifications for installation/repairs.
Safety advice for children, open grills, open flames, gas hobs, and condensation.
Specifies minimum safety distances to cookers/hobs and material requirements for ducting.
Instructions for external fans and safe disposal of old appliances.
Identifies the exhaust stub for ventilation and the slot for the active charcoal filter.
Refers to the control interface, fan switches, and hob illumination controls.
Identifies primary/secondary grease filters and the pull-out deflector plate.
Allows selection of fan speed and mentions lightshield accessory.
Explains how air is drawn, filtered, and expelled outside.
Details the process of filtering and re-circulating air back into the room.
Describes EX models designed for external fan connection.
Instructions on activating the fan by pulling out the deflector plate and switching it off.
Guide to choosing fan speed based on cooking needs.
How to operate the hob illumination independently of the fan.
Instructions for cleaning the appliance's exterior surfaces.
Information on the reusable metal filters and their cleaning frequency.
Step-by-step guide on how to remove the primary grease filter.
Instructions for removing the secondary grease filter.
Detailed instructions for refitting both secondary and primary grease filters.
Details on using and replacing the active charcoal filter for odour absorption.
Procedure for replacing light tubes or starters, including safety precautions.
Contact information for faults that cannot be easily remedied, including details to provide.
Unit height requirements and ensuring filter accessibility for recirculation mode.
Explains how depth requirements depend on the lightshield position.
Specifies building-in depth for flush fitting and matching furniture lightshields.
Covers gap with side spacers and stability with traverses for wall units.
Introduces the various accessories included for installation.
Lists the sequence of steps for installing the appliance.
Details fitting the non-return flap for air extraction or recirculation.
Instructions for fitting the reducing collar and appliance runners.
Instructions for fitting the furniture door and aligning appliance height.
Details appliance placement in the wall unit and depth adjustment.
Steps for fitting DFB and custom kitchen lightshields.
Instructions for fitting side spacers and the rear spacer strip.
Steps to fit the light cover and secure it with screws.
Instructions for setting up for vented extraction or recirculation.
Adapting runners for 19mm carcase sides.
Fitting runners to spacer blocks and cover caps for 70/90cm units.
Safety advice, regulations, and best practices for ducting installation.
General safety and wiring instructions for connecting the appliance to the power supply.
Information specific to non-rewireable plugs used in the UK.
Specifications for rated load, fan performance, lighting, voltage, frequency, fuse ratings, and test marks.
