Position for maintenance
The housing can be opened to clean
inside the cooker hood, remove the
grease filters and to change the lamps.
To open the housing
^ Switch the cooker hood on by
touching the On/Off sensor s or the
Hob lighting sensor n. The canopy
will open into the operating position.
^
Before opening the housing, clear
everything from the hob.
^
Holding the canopy on both sides of
the frame a, pull it down into a
horizontal position as shown (you will
feel a resistance).
Only pull on the outside edge of the
frame a.
Do not pull on the filter housing b or
on the glass slats c.
The canopy a hinges downwards
whilst the filter housing b hinges
upwards.
The fan and the hob lighting switch off
and cannot be switched on again whilst
the cooker hood is in the maintenance
position.
The open canopy cannot bear any
weight.
Do not lean on the open canopy or
place any objects on it.
Cleaning and care
24
To Next Page
Loading...
