Miele DGC 7450 - Special Accessories

Features
26
Baking tray, universal tray and rack
with non-tip safety notches
Baking tray HBB71:
Universal tray HUBB71:
Rack HBBR71:
Insert these accessories into the shelf
runners between the two rails of a shelf
level.
The rack has a rail at the back to
prevent dishes sliding off. Ensure the
rack is inserted so that the rail is facing
upwards.
Non-tip safety notches are located on
accessories to prevent the trays being
pulled out completely when you only
wish to pull them out partially. They also
prevent trays from tipping.
- The non-tip safety notches are
located in the middle of the short
sides of the baking tray and universal
tray.
- The non-tip safety notches are
located towards the back of the short
sides of the rack.
If you are using the universal tray with
the rack on top, insert the tray between
the rails of a shelf runner and the rack
will sit on top of it.
When using the Steam cooking
operating mode, always place the
universal tray on shelf level1 to catch
any liquid.
FlexiClip telescopic runners HFC71
You can use the FlexiClip telescopic
runners on shelf levels1–4.
Push the FlexiClip telescopic runners
right into the oven cavity before
placing accessories on them.
The accessories will then
automatically sit securely between the
stoppers at either end of each runner
and be prevented from sliding off.
The FlexiClip telescopic runners can
support a maximum load of 15kg.