Features
27
Fitting and removing the FlexiClip
telescopic runners
Risk of injury caused by hot
surfaces.
The steam combination oven gets
hot during operation. You could burn
yourself on the heating elements, the
oven compartment, or accessories.
Allow the heating elements, oven
compartment and the accessories to
cool down before fitting or removing
the FlexiClip telescopic runners.
The FlexiClip telescopic runners are
fitted in between the two rails that make
up a shelf level.
The FlexiClip telescopic runner with the
Miele logo is fitted on the right.
When fitting or removing the FlexiClip
telescopic runners, do not extend
them.
Hook the FlexiClip telescopic runner
onto the lower rail of a shelf level at
the front (1.) and push it along the rail
into the oven interior (2.).
Then secure the FlexiClip telescopic
runner to the lower rail of the shelf
level as illustrated (3.).
If the FlexiClip telescopic runners are
difficult to pull out after fitting, you
may need to pull firmly on them once
to release them.
To remove a FlexiClip telescopic runner,
proceed as follows:
Push the FlexiClip telescopic runner
in all the way.
Remove the FlexiClip telescopic
runner by raising it at the front (1.)
and then pulling it forwards along the
rail of the shelf level and out (2.).
To Next Page