Problem Possible cause Remedy
The buzzer sounds.
The following fault
message appears in
the display:
Before rectifying the problem:
–
Open the door.
–
Switch the dishwasher off
with the K sensor.
Technical fault FXX
Call Service
There may be a
technical fault.
After a few seconds:
–
Switch the dishwasher back
on.
–
Select the programme you
want.
–
Close the door.
–
Select
Start.
If the fault message appears
again, there is a technical
fault.
– Call the Service
Department.
Waterproof F70
The Waterproof system
has reacted.
– Close the stopcock.
– Call the Service
Department.
Fault with auto. door
closing
The door is sometimes
obstructed by an item
inside the appliance.
– If this is the case, remove
the item and switch the
dishwasher on again.
–
If the same message
appears again, call the Ser
-
vice Department.
Fault with auto. door
opening
There may be a
technical fault.
–
Open the door manually.
–
If the same message
appears again, call the Ser
-
vice Department.
Problem solving guide
55