Attaching and aligning the
custom door front
^
Fit the door handle to the custom
door.
Note that the screws are applied from
the reverse side.
^ Open the door and hang the custom
door with the adjusting rail over the
double-threaded bolts p.
^
Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^
Close the door.
^
Adjust the custom door to adjacent
furniture/fixtures.
^
Align the custom door with the
double-threaded bolts.
^
Tighten the nuts on the adjusting rail.
This will correct the side alignment of
the door.
^
Put the side strips (15) back into place
and screw them completely down on
both sides of the appliance door.
^ Align the custom door again as needed
and tighten all screws on the sides.
Attaching the lower bracket
(Only for appliances using the "Front
panel gap kit".)
^
Open the appliance door.
^
Screw on the lower brackets. Pre-drill
holes in the custom door.
Installing the appliance
64
To Next Page
