600 mm wide appliances can be in-
stalled into a kitchen run. To match the
height of the rest of the kitchen the ap
-
pliance can be fitted with a suitable top
box a.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The cross section of the air outlet must
be at least 300 cm
2
to ensure that air
can circulate without hindrance. Other
-
wise the appliance has to work too hard
resulting in an increase in electricity
consumption
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
When built into a kitchen run (max.
depth 580 mm) the appliance can be
installed directly next to a kitchen furni
-
ture housing unit. The appliance door
will protrude in front of furniture fronts at
the sides by 34 mm and by 51 mm in
the middle of the door. This enables the
door to be opened and shut without be
-
ing obstructed.
When installed next to a wall d a dis-
tance of approx. 36 mm is needed on
the hinge side between the wall and the
appliance, so that the door and the
handle have sufficient space for open-
ing.
When secured to adjoining furniture
c or if a spacer is fitted between the
appliance and the wall, please note the
following:
^
Ensure that the door has sufficient
space for opening fully after the ap
-
pliance has been secured.
^
Do not drill within the area marked
with a criss cross pattern as this
would damage insulated parts of the
appliance.
^
To secure the appliance to adjoining
kitchen furniture use self tapping
screws. The depth of the screw must
not exceed 10 mm.
Building in
32
To Next Page
