Prepare the appliances
^
Place the appliances next to each
other in the intended configuration.
Remove the mounting frames located
on the top and inside (handle side) of
each appliance.
^ On each appliance, remove the
screws a from the upper mounting
frame b and pull the frame up and
off.
^
Loosen the screws c a few turns on
the side mounting frame d of each
appliance.
^
Slide each side mounting frame d
slightly upward and then outward to
unhinge.
^
Screw the screws c all the way in
again or remove them completely.
^ Take the hinge halves e from the
side-by-side kit and screw them to
both appliances.
^
Screw the side plates f to both
appliances. Check the position of
both appliances!
en
5
To Next Page
Loading...
Need help?
General
