Preparing the appliance
^ Slide cover strip a into the holder in
the middle of the appliance with the
bumps facing downwards. The
bumps will fit into the keyhole slots.
^ Position the mains electricity cable so
that the appliance can be connected
easily once installed.
^
Push the appliance three-quarters of
the way into its niche.
When doing this, make sure that the
mains cable does not get trapped.
^
With 16 mm thick furniture walls:
Clip spacers b over the hinges.
^
Open the appliance door.
^ Remove the cover c on the top
corner of the appliance, using a
screwdriver.
^
Fit the cover d onto the fixing
bracket e.
^
Secure the fixing bracket e to the
top of the appliance with the screws
f (M5 x 15).
Building in the appliance
41
To Next Page
Loading...
Need help?
General
