Miele G 1143 SCi - Adjust Sensor Wash

Adjust sensor wash
You can adjust the sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^
Switch the dishwasher off with the
On/Off button s.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button five
times.
The "Delay start" indicator will flash
briefly five times at intervals.
The characters flashing in the display
show whether the "Adjust sensor wash"
function is activated or deactivated.
–
"p 1": The "Adjust sensor wash"
function is activated.
–
"p 0": The "Adjust sensor wash"
function is deactivated.
^
To change the setting, press the
Start/Stop button.
Switch the dishwasher off with the
On/Off button s.
Operation
38
Downloaded from DishWasher-Manual.com Manuals