Technical Information
30
G 1xxx/G 2xxx
Function Programming Display
Dispensed rinse aid
quantity setting
Press the Program (or
Delay Start for G 2143)
button 3x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 3x
rapidly. If the "Rinse" LED flashes
3x rapidly, this corresponds to
standard setting of 0.1 fl.oz. (3 mL).
Range: 0 - 0.2 fl.oz. (0 - 6 mL); see
Table 23.
Resetting standard
settings
Press the Program (or
Delay Start for G 2143)
button 12x. Press the
Start/Stop button to
reset all standard settings.
The "Rinse & Hold" LED flashes 1x
slowly and 2x rapidly. "Rinse" LED
is off: values do not correspond to
standard settings; "Rinse" LED
flashes: values correspond to
standard settings.
Adjusting the main wash
temperature
Press the Program (or
Delay Start for G 2143)
button 20x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 2x
slowly. "Rinse" LED is off: standard
setting; "Rinse" LED flashes:
increased wash temperature.
Increased wash temperature results
in longer running time.
Shortening program
sequence
Press the Program (or
Delay Start for G 2143)
button 22x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 2x
slowly and 2x rapidly. "Rinse" LED
is off: Standard setting; "Rinse" LED
flashes: Shortened wash program.
Program-dependent shortening of
running time by reduction of
temperature and/or removing
holding times.
Water quantity
normal/increased
Press the Program (or
Delay Start for G 2143)
button 23x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 2x
slowly and 3x rapidly. "Rinse" LED
is off: Standard setting; "Rinse" LED
flashes: Increased water quantity. If
“Increased water quantity” is
selected, water intake increases by
approx. 16.7 fl.oz. (500 mL).
Second interim rinse
Press the Program (or
Delay Start for G 2143)
button 26x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 2x
slowly and 6x rapidly. "Rinse" LED
is off: Standard setting; "Rinse" LED
flashes: With second interim rinse.
Activating/deactivating
improved drying
Press the Program (or
Delay Start for G 2143)
button 27x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes
2x slowly and 7x rapidly. "Rinse"
LED is off: Standard setting; "Rinse"
LED flashes: Improved drying –
depending on the program, drying
time is extended and the final rinse
temperature increased.
Appliance width setting
1
Press the Program (or
Delay Start for G 2143)
button 35x. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse & Hold" LED flashes 3x
slowly and 5x rapidly. "Rinse" LED
is off: Appliance width 24” (60cm)
(standard setting); "Rinse" LED
flashes: Appliance width 18”
(45cm).
To Next Page
Loading...
Need help?
General
