Technical Information
6
G 1xxx/G 2xxx
Function Programming Display
Adjusting the main wash
temperature
Press the Program button
20x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 2x
slowly. "SaniWash" LED is off:
standard setting; "SaniWash" LED
flashes: increased wash
temperature. Increased wash
temperature results in longer
running time.
Shortening program
sequence
Press the Program button
22x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 2x
slowly and 2x rapidly. "SaniWash"
LED is off: Standard setting;
"SaniWash" LED flashes:
Shortened wash program. Program-
dependent shortening of running
time by reduction of temperature
and/or removing holding times.
Water quantity
normal/increased
Press the Program button
23x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 2x
slowly and 3x rapidly. "SaniWash"
LED is off: Standard setting;
"SaniWash" LED flashes: Increased
water quantity. If “Increased water
quantity” is selected, water intake
increases by approx. 16.7 fl.oz.
(500mL).
Second interim rinse
Press the Program button
26x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 2x
slowly and 6x rapidly. "SaniWash"
LED is off: Standard setting;
"SaniWash" LED flashes: With
second interim rinse.
Activating/deactivating
improved drying
Press the Program button
27x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes
2x slowly and 7x rapidly.
"SaniWash" LED is off: Standard
setting; "SaniWash" LED flashes:
Improved drying – depending on the
program, drying time is extended
and the final rinse temperature
increased.
Appliance width setting
1
Press the Program button
35x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 3x
slowly and 5x rapidly. "SaniWash"
LED is off: Appliance width 24”
(60cm) (standard setting);
"SaniWash" LED flashes: Appliance
width 18” (45cm).
Appliance height setting
1
Press the Program button
36x. To make the desired
setting, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
The "Intake/Drain" LED flashes 3x
slowly and 6x rapidly. "SaniWash"
LED is off: Standard appliance
height (G 1xxx); "SaniWash" LED
flashes: XXL models (G 2xxx).
To Next Page
Loading...
Need help?
General
