Technical Information
9
G 1xxx/G 2xxx
Function Programming Display
Water hardness setting
1
Press the Delay Start
button 2x. The "Delay
Start" LED flashes 2x
rapidly intermittently.
Press the Start/Stop
button as appropriate to
set the desired water
hardness.
The "Rinse" LED is out or flashes.
The display shows p and the digit/s
of the set value alternately.
Setting range: p1 to p70; see Table
6.
2
Dispensed rinse aid
quantity setting
Press the Delay Start
button 3x. The "Delay
Start" LED flashes 3x
rapidly intermittently.
Press the Start/Stop
button as appropriate to
make the desired setting.
The "Rinse" LED is out or flashes.
The display shows P and a digit
alternately: e.g., P3 (standard
setting) indicates a dispensed
quantity of 0.1 fl.oz. (3mL). Setting
range: 0 - 0.2 fl.oz. (0 - 6 mL). See
Table 7.
Adjust Sensor Wash
program
Press Delay Start 5x. The
"Delay Start" LED flashes
5x rapidly intermittently.
Press the Start/Stop
button to change the
setting.
The "Rinse" LED is out or flashes.
The display shows P and a digit
alternately. Setting options: P0 =
Standard program cycle (factory
setting); P1 = Adjusted program
cycle. The Sensor Wash program
can be adjusted in this parameter to
deal with stubborn soiling (or
otherwise low overall soiling). If this
option is selected, the main wash
temperature is increased to 131°F
and, as a result, the program
duration is extended.
Resetting standard
settings
Press Delay Start 12x.
The "Delay Start" LED
flashes 1x slowly and 2x
rapidly intermittently.
Press the Start/Stop
button to reset all settings
back to their factory
values.
The "Rinse" LED is out or flashes.
This programmable function can be
used to reset all customer-modified
parameters back to their standard
settings. The display shows P and a
digit alternately. P0 = Settings have
been modified; P1 = All settings reset
to standard settings or no
modifications have been made.
Adjusting the main wash
temperature
Press the Delay Start
button 20x. The "Delay
Start" LED flashes 2x
slowly. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is out or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
Standard setting; p1 = Wash
temperature increased. If this option
is selected, the main wash
temperature is increased and, as a
result, the program duration is
extended.
To Next Page
Loading...
Need help?
General
