Problem Possible cause Remedy
The In-operation
indicator is flashing
quickly.
The buzzer is sounding.
One of the following
messages appears in
the display:
Technical fault! Switch the
appliance off, turn off the
water supply and call the
Service Department.
There may be a
technical fault.
–
Clean the water inlet and
clean the drain pump and
non-return valve as
described in
"Maintenance". If this does
not resolve the problem:
– switch the dishwasher off
with the Off button V.
After a few seconds:
– Switch the dishwasher on.
– Select the programme you
want.
– Close the door.
If the fault message appears
again, there is a technical
fault.
–
Call the Service
Department.
Waterproof fault F70
The Waterproof system
has reacted.
–
Close the stopcock.
–
Call the Service
Department.
Fault with auto. door
closing
The door is sometimes
obstructed by an item
inside the appliance.
–
Remove the obstruction.
–
If this is not the case, call
the Miele Service Dept.
Fault with auto. door
opening
There may be a
technical fault.
–
Open the door manually.
–
Call the Service
Department.
Problem solving guide
49
To Next Page
Loading...
