The dishwasher does not fill/drain
Problem Possible cause Remedy
The In-operation
indicator is flashing
quickly.
The buzzer is sounding.
One of the following
messages appears in
the display:
Water inlet fault
The stopcock is closed. Open the stopcock fully.
Water inlet fault FXX
Before rectifying the problem
you must:
– Switch the dishwasher off
with the Off button V.
Fault F12/F13:
Water intake is
restricted.
– Open the stopcock fully.
– Check the water inlet filter
and clean it if necessary
(see Maintenance).
– The water pressure at the
intake is lower than
30 kPa (0.3 bar).
Seek professional advice.
Problem solving guide
50
To Next Page
Loading...
