Options
44
Factory default settings
If you have altered any settings from
the factory default, you can reset them
back to the factory default settings as
follows:
ĺ Open the door.
ĺ Turn the dishwasher off with the ɶ
button, if it is turned on.
ĺ Press the program selection button
Ҳ, and, simultaneously switch the
dishwasher on using the ɶ button.
Keep the program selection button Ҳ
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
ĺ Press the Ц button 19 times.
The Ц indicator light will flash once at
a long interval and then 9 times at short
intervals.
The flashing sequence in the display in‐
dicates whether a setting has been
changed from its factory default.
– ɠɇ: All settings are set to factory de‐
fault settings
– ɠɆ: At least one setting has been
changed
ĺ To reset the dishwasher to the factory
default settings, press the program
selection button Ҳ.
The setting is now stored in memory.
ĺ Turn the dishwasher off with the ɶ
button.
To Next Page
