Cleaning and care
74
Cleaning the water inlet filter
A filter is incorporated in the screw
thread to protect the water inlet valve. If
the filter is soiled, insufficient water
flows into the wash cabinet.
Risk of electric shock.
The plastic housing of the water
connection contains an electrical
valve.
The housing must not be dipped in
water.
Disconnect the dishwasher from the
power supply.
To do this, switch off at the socket
and withdraw the plug.
Turn off the tap.
Unscrew the water inlet valve.
Carefully remove the seal from the
threaded union.
Using combination or pointed pliers,
take hold of the plastic filter bar and
remove the filter.
Rinse the filter under running water.
Reassemble in reverse order.
Screw the threaded union securely
back onto the tap. Slowly turn on the
tap. If water drips out, tighten the
connection.
Never forget to put the filter back in
place after cleaning.
To Next Page
Loading...
