Problem Possible fault Solution
In the program
"Energy Saver" the
following fault is
displayed:
Water intake temp. too
low
The intake water does not
have a minimum
temperature of 115°F
(45°C). See "Plumbing".
–
Restart the program.
–
If the fault is displayed
again, use a different
program.
The buzzer sounds.
The display shows
the following error
message:
Drain fault F11
Before fixing the fault:
–
Turn the dishwasher off
with the K button.
Fault in the water drain.
There might be water in
the wash cabinet.
–
Clean the triple filter.
–
Clean the drain pump and
the non-return valve.
See "User Maintenance
Instructions" for more
information on the above.
– Remove any kinks in the
drain hose.
Frequently asked questions
63
To Next Page
