^
Align the cover plate to the front
edge of the worktop in the middle of
the niche.
If the worktop has a very rounded
edge, pull the cover plate further
forward so that the reflector panel is
still visible later on.
^ Use the tacks supplied to nail the
cover plate to the underside of the
worktop.
Worktops with wood or laminate
edging:
Nail the tacks through the holes
further back from the edge.
^
Use soapy water to wipe off any
excess sealant.
^
Press the reflector panel into the
plastic holder in the cover plate.
Installation
7
To Next Page
Loading...
