Miele G 618 - Cover Plate Fitting for Hard Worktops; Granite and Marble Worktop Fitting

Granite or marble worktops:
Worktops made from hard materials
such as granite or marble do not need
the cover plate for protection. The
cover plate is only used as a guide for
marking the position for the reflector
panel plastic holder.
Keep the cover plate in case the
dishwasher is ever fitted under another
type of worktop.
^
First, remove the protective foil
covering the plastic holder for the
reflector panel and then take the
holder out of the cover plate.
^
Align the cover plate to the front
edge of the worktop in the middle of
the niche. Draw around the cut-out
for the plastic holder.
If the worktop has a very rounded
edge, pull the cover plate further
forward so that the reflector panel is
visible later.
^
Stick the doublesided adhesive strip
supplied onto the back of the plastic
holder.
^
Remove the protective foil from the
adhesive strip and stick the holder to
the underside of the worktop at the
marked position.
^ Press the reflector panel into the
plastic holder.
Installation
8