Operation
52
Switching on
Make sure the spray arms are not
obstructed.
Close the door.
Turn on the tap if it is turned off.
Press the button for at least
2seconds.
The programme selected will appear
briefly in the display and the
appropriate indicator light will come on.
Then, if applicable, the estimated
energy and water consumption for the
programme selected will appear for a
few seconds.
Finally, the display will show the
estimated programme duration for the
programme selected.
Selecting a programme
Choose your programme according to
the type of load and how dirty it is.
The different programmes and their
uses are described in the Programme
chart later on in this booklet.
Use the programme selector button
to select the programme required.
The indicator light next to the selected
programme will come on.
Further programmes are selected via
the Further option.
Use the programme selector button
to select the Further option.
The first of the further programmes will
appear in the display.
Use the arrow buttons to select
the programme required.
During the course of the programme
you can use OK to display the name of
the programme which is currently
running.
You can now select programme options
(see “Programme options”).
If any programme options are selected,
the appropriate indicator lights will also
light up.
To Next Page
Loading...
Need help?
General
