Miele G 685 - Troubleshooting: Wash Cycle Cancellation; Troubleshooting: Water Inlet Issues

The wash cycle is cancelled before
the end and the “Water outlet” check
light flashes
– The drain hose is kinked.
– The drain pump is blocked – see
“Cleaning and care”.
– Foreign bodies are obstructing the
non-return valve - see "Cleaning and
care".
Before removing the obstruction:
Turn the programme selector to
STOP.
Switch off the dishwasher with the
ON / OFF switch.
Water in the wash cabinet at the end
of a programme
– The outlet hose is kinked.
– The drain pump is blocked
– see “Cleaning and care”.
– Foreign bodies are obstructing the
non-return valve – see "Cleaning and
care".
Before removing the obstruction:
Turn the programme selector to
STOP.
Switch off the dishwasher
with the ON/OFF switch.
Shortly after starting a programme
the “Water inlet”check light flashes
– The stopcock is shut.
Open the stopcock.
The dishwasher should continue
the programme.
If the programme does not continue:
Turn the programme selector to
STOP.
Switch off the dishwasher with the
ON/OFF switch.
Start the programme again
- see "Switching on and off".
– The filter in the screw connection of
the valve on the water inlet hose is
blocked - see "Cleaning and care".
– Too little water flows into the wash
cabinet. This may be due to insuffi-
cient water pressure at the intake
(flow pressure at the water inlet).
Before removing the obstruction:
Turn the programme selector to
STOP.
Switch off the dishwasher with the
ON/OFF switch.
Problem solving guide
48