Miele G 7100 SCU User Manual

Problem solving guide
71
Door release
Problem Cause and remedy
The following fault is in-
dicated via the display:
Before rectifying the problem:
 Switch the dishwasher off.
Fault F33 The door does not open automatically.
There may be a technical fault.
 Open the door manually (see “Before using for the
first time” chapter, “Opening the door” section)
and switch the dishwasher off and then back on
again.
 If the same fault message appears again, call
Miele Service.
The door locking pins do not retract after the door is
opened.
There may be a technical fault.
 Switch the dishwasher back on.
 If the same fault message appears again, call
Miele Service.

Miele G 7100 SCU Specifications

General

Door color	Stainless steel
Water fill	Cold, Hot
Cord length	1.7 m
Control type	Buttons
Product size	Full size (60 cm)
Built-in display	Yes
Inlet hose length	1.5 m
Appliance placement	Undercounter
Cycle time	238 min
Noise level	44 dB
Delay start (max)	24 h
Dishwashing programs	Auto, Eco, Intensive, Normal
Number of place settings	14 place settings
Number of washing programs	8
Current	10 A
Connected load	2000 W
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (off)	0.3 W
Water consumption per cycle	8.9 L
Energy consumption per cycle	0.75 kWh
Drying class	A
Annual water consumption	2492 L
Annual energy consumption	213 kWh

Weight and Dimensions

Depth	570 mm
Width	598 mm
Height	805 mm
Weight	48500 g
Depth with door open	1165 mm
Installation compartment width	600 mm
Installation compartment height	870 mm