Cleaning and care
71
Inserting the upper spray arm
Refit the upper spray arm and tighten
it by hand.
Inserting the middle spray arm
Replace the middle spray arm and
turn the screw thread anticlockwise
until it engages. Make sure that the
recesses in the lock line up.
Inserting the lower spray arm
Refit the lower spray arm and ensure
that the filter combination lies flat in
the base of the wash cabinet.
Rotate the screw thread of the lower
spray arm clockwise until the arrow in
the viewing window points to the lock
symbol.
Make sure the spray arms can rotate
freely.
Damage due to soiling entering
the circulation system.
The lower spray arm is used to se-
cure the filter combination. Without
filters, coarse soiling can enter the
circulation system and cause a
blockage.
Do not run a wash programme
without the lower spray arm or
without the filters.
Inserting the cutlery tray (if present)
Slide the cutlery tray back onto the
rails from the front.
Replace the safety clips in the rails on
both sides of the cutlery tray.
To Next Page
Loading...
