Miele G 7319 - Page 91

Problem solving guide
91
Problem Possible cause and remedy
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
Fault F601
There is a fault with the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see
“Detergents – Automatic dispensing/AutoDos”).
 Activate the AutoDosfunction and start the
programme again.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating automatic dispensing
with the AutoDossensor and manually dispensing
the detergent via the detergent compartment.
 If you wish to use automatic dispensing again,
contact Miele.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
AutoDos maintenance
required
The dishwasher does
not switch off at the end
of the programme.
The dishes may not be
clean because an
insufficient amount of
detergent was
dispensed.
The AutoDos
function is
automatically
deactivated during the
programme sequence.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDos function was automatically
deactivated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the detergent chute of the AutoDos (see
“Cleaning and care - Cleaning the AutoDos”).
 Clean the lower spray arm (see “Cleaning and care
- Cleaning the spray arms”).
 Confirm each message with OK.
 Activate the AutoDos function by confirming the
message AutoDos available with OK.
 Restart the programme.
The programme duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.