Technical Information
117
G 600/G 800
Stage Stage function Illuminated light
Stage 1 Fault codes Rinse
Stage 2 Program index Drying
Stage 3 Function programming End
Table 6-54: G 694, G 894 Service Mode 2 Stages
6.8.10.3.1 Stage 1
1. To access Stage 1 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Intake/Drain and Salt lights and a lit Rinse light indicate successful accessing
of Stage 1 of Service Mode 2.
3. The display will indicate the last fault stored.
4. Use the fault code chart (Table 6-55) to determine the stored fault code.
5. To delete stored fault codes, access the Programming Mode and press Start/Stop
twice.
Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
F03 Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective electrical
component in heating circuit
F05 Water drainage failure, heater level switch
F06 Too few pulses at flow meter / start of water intake
F07 Too few pulses at flow meter / end of water intake
F08 Water intake failure, heater level switch
F09 Heater level switch not switching on at the end of thermal stops
Table 6-55: G 694, G 894 Fault Code Chart
6.8.10.3.2 Stage 2
1. To access Stage 2 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Intake/Drain and Salt lights and a lit Rinse light indicate successful accessing
of Service Mode 2.
3. Press the Top solo button once. Flashing Intake/Drain and Salt lights and a lit Drying
light indicate successful accessing of Stage 2 of Service Mode 2.
4. The display will indicate the current electronic version.
5. To save, press the Start/Stop button twice.
6.8.10.3.3 Stage 3
1. To access Stage 3 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
To Next Page
Loading...
Need help?
General
