Turning on the dishwasher
^
Make sure spray arms are not
blocked.
^ Close the door.
^ Open the water valve, if closed.
^ Press the “On/Off” button (16).
All indicator lights (17) next to the pro-
gram buttons and the decimal point in
the time display (19) light .
Starting a program
^
When selecting a program, refer to
the Program Chart of the operating
instructions.
^
Press button (17) for program
choice.
All indicator lights next to the program
buttons, except the selected program,
go out.
The indicator light next to the “Start/
Stop” button comes on.
The running time of the program
selected appears in the time display
(19) in hours and minutes.
The “Time Left” indicator lights.
Note:
“Delay start” or “Top Solo” must be se-
lected before the program is started
(see “Additional features”).
^ Press the “Start/Stop” button (22).
The indicator light next to the
“Start/Stop” button goes out. The pro-
gram cycle begins.
Do not end a program prematurely
or important program steps could
be omitted (e. g. reactivating the
water softener).
Program sequence indicator
lights (15)
After a program has been started the
current step of the program is indicated
by the program sequence indicator
lights (15).
Operating the dishwasher
31
To Next Page
