Problem Possible cause Remedy
The “Water intake” indi
-
cator light flashes
shortly after the start of
a program
The water valve is closed. Open the water valve
fully.
If the program will not
continue:
–
Press “Start/Stop” for at
least 1 second.
All indicator lights next to
the program buttons light.
–
Turn off the dish-
washer.
–
Restart the program .
The flow pressure at the
water inlet is lower than
4.5 psi (0.3 bar).
Seek professional advice.
Contact a plumber.
The filter in the water inlet
is blocked.
Before fixing the problem:
– Press the “Start/Stop”
button for at least
1 second.
All indicator lights next to
the program buttons light.
– Turn off the dishwasher
with the “On/Off” but
-
ton,
–
Clean the water inlet
filter.
The “Water intake” indi
-
cator lights during the
“Energy Saver” pro
-
gram
The intake water has not
reached the required
temperature of
45 °C/115° F, the hot wa
-
ter system may be over
-
loaded, see “Program se
-
lection”.
–
Start the program
again.
–
If the indicator light
comes on again, select
a different program.
Problem solving guide
44
To Next Page
Loading...
