Miele G6620SC - Optimise Standby

Programme options
56
Optimise standby
"Optimise standby" is activated by de-
fault.
To save energy the dishwasher will
switch off automatically a few minutes
after the last time a button has been
pressed or after the end of a pro-
gramme.
The dishwasher will not switch off
whilst a programme is running, during
the Delay start period or if there is a
fault.
Optimise standby can be switched off if
you prefer. If you do this the duration
before the dishwasher switches off
automatically increases to approx. 6
hours. Doing this will increase energy
consumption.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and whilst
holding it in switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
 Press the  button eight times.
The  indicator will flash rapidly eight
times at intervals.
The flashing sequence in the display
shows whether Optimise standby is ac-
tivated or not.
–  : "Optimise standby" activated
–  : "Optimise standby" deactivated
 Press the Start button to change the
setting.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.