Miele HFC 60 - AU, NZ - en

Application
HFC 60/61 H 5xxx E/EP/B/BP
HFC 91 H 59xx B/BP
The FlexiClip telescopic runners can be
used on any shelf level and drawn right
out of the oven to give a good overview
of cooking in progress.
The surface of the telescopic runners
can have an iridescent appearance.
Fitting instructions
,
Danger of burning!
Make sure that the oven has cooled
down before fitting the telescopic
runners.
The telescopic runners are fitted in
between the two rails that make up a
shelf level.
The telescopic runner with the Miele
logo is fitted on the right.
When fitting the telescopic runners
do not extend them.
^
Fit the telescopic runner in between
the two rails at the front (1) and then
push it into the oven compartment
(2).
^
Then secure the telescopic runner
to the bottom of the two rails as
illustrated (3).
If the telescopic runners are difficult
to pull out after fitting, you may need
to pull firmly on them once to release
them.
Removing the telescopic runners
,
Danger of burning!
Make sure that the oven has cooled
down before removing the
telescopic runners.
^
Remove the telescopic runners by
raising them at the front (1) then
pulling them forwards along the shelf
rails and out (2).
AU, NZ - en
6