The appliance is supplied right-hand
hinged. If left-hand door hinging is
required, follow the instructions below.
To change the door hinging you will
need the following tools:
–
a cross-slotted screwdriver,
–
a flat-bladed screwdriver,
–
a selection of Torx screwdrivers,
–
a spanner.
Two people are needed for
changing the door hinging.
Removing the door handle
^
Pull door handle a towards you. Side
section b slides back.
^
Pull side section b firmly back out of
the guides on the mounting plate.
^
Undo the 4 screws (Torx 15) in the
mounting plate, and remove the
handle.
^
Remove the cover caps from the
opposite side, and fit them into the
empty holes.
Changing the door hinging
43
To Next Page
Loading...
