^
Slide soft-close mechanism bracket
f as far as it will go towards the
handle side of the door, and undo
screws g on the soft-close
mechanism.
^ Using a flat-bladed screwdriver, slide
the soft-close door mechanism
towards the handle side of the door,
and lever it out at the side.
^ Then place it to one side.
Changing over the door
Make sure the door shelves are
empty!
^
Close the door.
^
Remove cover a by sliding it
forwards from the back and then
lifting it off.
^
Remove cover b by pulling it
upwards.
Caution. The door is not secure as
soon as the hinge plate is removed.
^
Loosen screws d in upper hinge
plate c and pull it upwards and off.
^
Carefully lift the door off and place it
to one side.
^
Gently loosen cover e by carefully
inserting a flat-bladed screwdriver
into the gap from below.
^ Remove cover e together with
retaining plate f.
^ Then separate retaining plate f from
cover e, by pushing it slightly to the
left and then pulling the cover
forwards and off.
^ Rotate retaining plate f by 180°.
^ Then fit cover e from the front over
retaining plate f, and slide it over to
the right. The writing must be visible.
^
Remove cover g, rotate it by 180°
and fit it to the opposite side.
Changing the door hinging
45
To Next Page
Loading...
