^
Loosen the screws on the rear side of
the appliance p. Do not unscrew
completely.
^ Hang the cable cover by its hinge on
the heating mat and, from below,
push into the screws q.
^ Tighten the screws r.
Connect the appliances
^ Push the appliances together until
the hinge halves interlock.
^
Insert the pins s into the hinges.
^ Push the appliances together as far
as possible.
^
Once the appliances have been
pushed together, insert the metal
bracket t into the upper and lower
plates. Use a tool to push the bracket
in all the way.
7
en
To Next Page
Loading...
Need help?
General