To confirm the filter has been
changed
The reminder to change the filter
continues to flash.
^
Touch the access sensor so that it is
highlighted in yellow.
The various zones in the appliance are
now visible.
^ Touch the sensor for the refrigerator
zone so that it is highlighted in
yellow.
^
Take note of the position of the X
sensor (but do not touch it!).
^
Touch the access sensor until it is
highlighted in white and all of the
other sensors are no longer lit up.
^
Place your finger in the position of the
X sensor, and leave it there.
^
At the same time, briefly touch the
access sensor (without moving your
finger from the X sensor).
^
Leave your finger on the X sensor for
another 4 seconds until the
; and the
Y sensors also appear in the display.
^
Now touch the X sensor repeatedly
until ^ appears in the display.
^
Touch the access sensor again.
^
By touching the X sensor you can
now select:
^0: The water filter is fitted
^1: The reminder to change the
filter is deactivated
(standard setting)
^2: To confirm the filter has been
changed
^ –: Return to menu
^ Touch the X sensor repeatedly until
^2appears in the display.
The ^1function should only be
selected if the household water
supply is already fitted with a water
filter. If this is the case, use the
standard water filter in your
appliance.
^
Now touch the access sensor for 2
seconds to confirm that the filter has
been changed.
This activates the reminder for the next
filter change.
^
Touch the X sensor repeatedly until
^ – appears in the display.
^
Touch the access sensor.
Water filter
54