Building in
Fit wall units and the cooker hood
before fitting the ceramic hob, to
avoid damaging the hob.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C heat
resistant adhesive which will not
dissolve or distort. Any backmoulds
must be of heat-resistant material.
~
Ideally the hobs should be installed
with plenty of space on either side.
There may by a wall at the rear and a
wall or tall unit at one side. On the other
side, however, no unit or divider may
stand higher than the hob (see
illustrations).
~
An electric fryer must not be
installed next to a gas hob, as the gas
flames could ignite the fat in the fryer. It
is essential to maintain a safety
distance of at least 288 mm between
these two appliances.
Due to the heat radiated by the hob
and to allow cooking fumes to
dissipate it is essential that a
minimum safety distance a is
maintained between the worktop
cut-out and adjacent kitchen units,
e.g. a tall unit, as follows:
40 mm = KM 400, 400-3, 402,
403, 412, 418, 418-1
50 mm = 408-1, 408-2
250 mm = KM 410, 411, 411-3
There must be a minimum safety
distance of 50 mm between the hob
and a back wall.
recommended
not recommended
not allowed!
Warning and Safety instructions
3
To Next Page
Loading...
