Miele KSK 2001 - Page 40

en - Securing a side-by-side combination
40
Side-by-side installation
These side-by-side merging kit installa-
tion instructions apply to the following
models:
- K26xxVi,K28xxVi,K29xxVi
- F241xVi,F28xxVi,F29xxVi
- F24xxVi,F26xxVi
- KF28xxVi,KF29xxVi
- KWT26xxVi,KWT26xx ViS
It is essential to read these installa-
tion instructions as well as the oper-
ating and installation instructions for
your refrigeration appliances before
setup, installation and use.
 Danger of injury due to electric
shock.
The supply voltage is applied to the
appliance even if it is switched off.
Unplug both appliances from the
mains power supply prior to com-
mencing side-by-side installation.
The refrigeration appliances must be
installed side by side before in-
stalling them in the niche.
 Danger of damage and injury
due to appliances tipping over.
The refrigeration appliances are very
heavy and can tip forwards when the
doors are open.
Keep the doors shut until the appli-
ances have been built in and secured
in their housings in accordance with
the operating and installation instruc-
tions.
Due to their weight and size, the re-
frigeration appliances must be in-
stalled by two people.
The following tools are required for
side-by-side installation:
- Torx T20 screwdriver
- Cordless screwdriver
- Hammer
- Pipe wrench
In addition
- Material to place under the appli-
ances to protect the floor
- Adhesive tape