I Adding detergent
It is important to dispense the correct
amount, because. . .
. . . too little detergent results in:
–
Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–
Greasy particles clinging to the
laundry.
–
Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– higher water consumption because
an extra rinse is automatically
activated
– A burden to the environment.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i
Detergent for the pre-wash (divide
the total recommended amount as
follows: add
1
/
3
to compartment i
and
2
/
3
to compartment j). This
compartment is also used for starch
formulations when starching
separately.
j
Main wash including the Soak period
if selected
§
Fabric conditioner or liquid starch.
^
Close the detergent drawer.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
J Press the Start button
This starts the programme. The
maximum programme duration will then
show in the display.
How to wash correctly
25
To Next Page
Loading...
