How to replace the AirClean exhaust
filter? (see fig. 29 + 30)
Make sure that only one exhaust
filter is inserted in the frame.
^
Open the dust compartment lid.
^
Open the filter frame and remove the
used AirClean exhaust filter with the
clean corner (see arrow).
^
Insert a new AirClean exhaust filter.
But if you want to install an Active
AirClean 50 filter or HEPA AirClean
50 filter, you must heed the section
"Maintenance and care - Exchanging
exhaust filters".
^ Close the filter frame.
^ Close the dust compartment lid until
it clicks into place.
How do I change the Active AirClean
50 or the HEPA AirClean 50 exhaust
filter? (see fig. 31 + 32)
Make sure that only one exhaust
filter is inserted in the frame.
^
Open the dust compartment lid.
^
Lift the Active AirClean 50 or HEPA
AirClean 50 exhaust filter and remove
it.
^
Insert the new Active AirClean 50 or
HEPA AirClean 50 exhaust filter and
press it downwards.
^
Press the exhaust filter change
indicator ~ (see fig. 11).
^
After about 10-15 seconds, a small
red marker will appear in the left-hand
side of the display (see fig. 12).
If you want to install an AirClean
exhaust filter, you must adhere to
the section "Maintenance and care -
Exchanging exhaust filters".
^
Close the dust compartment lid until
it clicks into place.
Exchanging exhaust filters
Make sure that only one exhaust
filter is inserted in the frame.
Depending on the model, your vacuum
cleaner will use one of the following
standard exhaust filters (see fig. 8):
a AirClean Filter
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Important
1. If you replace exhaust filter a with
exhaust filter b or c, you must be sure
to remove the filter frame before
inserting the new filter type. The
exhaust filter change indicator must
also be activated (see fig. 11).
2. If you replace exhaust filter b or c
with exhaust filter a, you must be sure
to place the new filter in the filter frame
* (see fig. 31).
* Filter frame - see section on "Optional
accessories"
en
16
To Next Page
Loading...
Need help?
General
