Miele SE 213 - Page 12

Electrical connection
@ä
Electrical connection of the
appliance should be undertaken by
a qualified electrician in strict ac-
cordance with national and local
safety regulations.
Caution:
In order to avoid a hazard this ap-
pliance must be installed according
to these instructions for installation.
Fusing arrangements must be accord-
ing to national and local standards.
Connection should be made via a suit-
able isolator switch which complies
with national and local regulations. It
should be easily accessible for servic-
ing work.
The data plate, located at the rear of
the appliance, gives the necessary
connection rating, which must be ac-
cording to national and local stand-
ards.
When contacting the Service Depart-
ment, please quote the voltage, model
and serial numbers given on the data
plate.
The wire which is coloured green and
yellow must be connected to the termi-
nal in the plug which is marked with the
letter E or by the earth symbol z or
coloured green or green and yellow.
The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
The wire which is marked brown must
be connected to the terminal which is
marked with the letter A or coloured red.
WARNING
THIS APPLIANCE MUST BE
EARTHED.
Electrical connection
@ä
12