Problem Possible cause Remedy
Sometimes a programme
cannot be started and
the corresponding
programme indicator
light does not light up.
No obvious cause.
–
Switch the dryer off and
back on again.
–
Select one of the
programmes.
–
If it still will not start,
there is a fault. Contact
the Miele Service
Department.
The Start/Stop indicator
light is flashing slowly
and the display is dark.
The dryer is in Standby
mode.
This is quite normal and
not indicative of any
fault.
See "Programmable
functions".
The tumble dryer fails to
start when switched on.
No obvious cause. – Is the dryer switched
on?
– Is the plug correctly
inserted into the socket
and switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Power cut. A programme which was running previously will
continue automatically when power is restored to the
tumble dryer as long as the Cooling down phase
had not been reached.
The interior drum
lighting does not come
on.
The lighting switches off
automatically (to save
energy).
Switch the dryer off and
then on again.
The lamp needs
changing.
Change the lamp, as
described at the end of
this section.
Problem solving guide
37
To Next Page
Loading...
Need help?
General
