Miele T 8623C User Manual

Problem Possible cause Remedy
Clean out airways
appears after the
programme has
finished
–
The dryer is not working
efficiently or economically.
Possible cause: The fluff
filters are clogged with fluff
or with detergent residues.
–
This message can also
appear when using the
Large pillows programme
to dry a large pillow. The
message does not indicate
a fault in this instance.
–
Cleaning the filters is
usually all that is required.
However, if the message
does not go out after you
have cleaned the filters,
then also check all the
possible causes described
under "The drying process
goes on too long or even
switches off".
To delete the fault
message:
–
Switch the dryer off and
then back on again.
You can adjust the setting
which controls when or if the
message
Clean out airways
appears. See "Settings
menu J, Airways indicator").
W
Clean out airways
+ the programme
is cancelled, the
buzzer sounds
See above for possible
causes and their remedies.
To delete the fault
message:
– Switch the dryer off and
then back on again.
–
Then start the programme
again.
–
If the fault message
appears again, contact the
Miele Service Dept.
,
Technical fault
Call the Service
Department
+ the programme
is cancelled, the
buzzer sounds
There is a fault.
A fault code, e.g.
F51 also
appears.
–
Switch the dryer off and
then back on again. Try to
start a programme.
–
If the fault message
appears again, contact the
Miele Service Dept.
Problem solving guide
34

Miele T 8623C Specifications

General

Brand	Miele
Model	T 8623C
Category	Dryer
Language	English