Cleaning and care
60
Cleaning the plinth filter
Clean the plinth filter when the pro-
gramme running time is longer than
usual or if the following message lights
up in the display: Clean the fluff and
plinth filters. See the operating instruction
manual for more information.
To clear the message, confirm with
OK.
Removing the plinth filter
Press the round, indented area on the
heat exchanger access panel to open
it.
The panel will spring open.
Pull the plinth filter out by the handle.
The right-hand guide pin comes out
when the plinth filter is removed. The
guide pin prevents the access panel
from closing without the plinth filter.
To Next Page
Loading...
Need help?
General
